MakerOnline
Tools
Go to Model
2.5" Conduit Clamp
23
Downloads
7
Likes
0
Makes
Here is a 2.5" Conduit Clamp that I designed in Onshape. there is one version with holes in the center and one with holes closer to the wall. 0.2mm Layer height 2 walls infill 15% - 100% (depends on your use) Rafts NO Supports NO Orrientation (on its side)
Desert3DPrinting also publishes on
98 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
