MakerWorld
Electronics
Ver Modelo
2"5 HDD enclosure
26
Descargas
4
Likes
17
Makes
Hi! I made this rugged case to protect a 2.5" HDD. It's a two-part case, the top and the bottom. To close it, I recommend using M3 screws by 10mm. If you have a HDD that's a bit thin, like an SSD, you can use other screws on the side to hold it in place even better! There you go, I hope it works for you.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
