Thingiverse
2.5 SSD USB Drive Case
von Azega
5
Downloads
5
Likes
0
Makes
This is a way to use the controller board from a shucked 3.5" WD Easystore drive to make an external USB3 case for a 2.5" drive. There are two different bottoms, one for 9mm thick drives and one for 7mm thick drives. The two halves snap together so it doesn't require any fasteners.
I had to file off a little of the corner of the board so it would fit with the rounded corners of the case without needing to increase the size.
I printed it in clear filament because I thought it would look nice and to see the LED. You could print in an opaque filament and drill a small hole for the LED.
Suggested print settings: 0.28mm layer height, 0.6mm line width, no infill, no support.
I had to file off a little of the corner of the board so it would fit with the rounded corners of the case without needing to increase the size.
I printed it in clear filament because I thought it would look nice and to see the LED. You could print in an opaque filament and drill a small hole for the LED.
Suggested print settings: 0.28mm layer height, 0.6mm line width, no infill, no support.
Azega veröffentlicht auch auf
27 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!