2.7 "Ez3D Super Max+" Model Rocket

## The 'Ez3D Super Max+' Model Rocket
- 3D printed parts for a rocket that flies on 29mm E and F motors
- Parts tape together - No glue required!

Tall thin structures (like rockets) can be a challenge to print. Ez3D Rocketry designs use 3D printing for the short, complex parts such as fin cans and nose cones while incorporating commercial cardboard body tubes as airframes.




###Parts List:

1. Ez3D-2980-4 Fin Can
2. BT80 Nose Cone
3. 29mm Retainer Cap
- Print out the multiple sizes (No scaling, +3%, +5%), These account for different printing tolerances and post flight shrinking.
4. Rail Guides
5. Eighteen (18) inches of BT-80 type body tube
- A standard 18 inch tube makes one kit
6. Four (4) feet of Kevlar string for Recovery Harness
- Flight tested on 9KM DWLIFE Black Braided Kevlar Cord (1.3mm, 300 lb) but others may work
7. Twelve (12) inch parachute (Streamer can also be used but it descends fast)
8. Tape


### Assembly:

1. Secure Rail Guides to Body Tube
2. Tie Rec