Thingiverse
2.8" Raspberry Pi watch
5
Downloads
6
Likes
0
Makes
Reused the parts from my previous design to make it into a watch form factor.
Uses
iUniker 2.8-inch lcd
Raspberry pi zero
sd card
HiLetgo TP4056 type-c (usb c bms)
20mm watch strap
18650 battery
90 Degree 4-Pin USB Type A Standard Port Female Solder Jacks Connector PCB Socket USB-A Type SMT (wires soldered to back of pi zero before soldering to lcd)
2 header pins (I'm using these to power the device on and off with a bent paperclip)
Parts were assembled with hot glue.
Message me if you need more information.
Uses
iUniker 2.8-inch lcd
Raspberry pi zero
sd card
HiLetgo TP4056 type-c (usb c bms)
20mm watch strap
18650 battery
90 Degree 4-Pin USB Type A Standard Port Female Solder Jacks Connector PCB Socket USB-A Type SMT (wires soldered to back of pi zero before soldering to lcd)
2 header pins (I'm using these to power the device on and off with a bent paperclip)
Parts were assembled with hot glue.
Message me if you need more information.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!