2 Blade Wind propeller

What you need to print :
1x p1
2x p2
2x p3 v1/v2

A screw is supposed to be put through the middle hole to spin it because plastic is too weak as shown with the previous 3 blade wind propeller. And I also used a drill to spin it but any motor does it.

difference between p3 v1 and p3 v2 is just the size. I couldn't print v1 becuse it was too big so I crated v2 which is smaller. You can choose either one of them but you need to print the same one ( You can't print 1x v1 and 1x v2 , you have to print 2x v1/v2).
I used hotglue to put the parts together that's what the connectors on the bottom of the wings are for.