Thingiverse
2 Channel Relay Module Mount Snap Fit
von ScottieD369
188
Downloads
91
Likes
2
Makes
This is for a Relay Module with dimensions: L 50.66mm x 38.6W mm
Stand-Off's are hole ready! (No drilling Necessary!!!)
Snap In Fit and flush mount
I also made this so that it can fit ~ 6mm Length screws. (board mount)
Lightweight & Strong Base Support!
I used Fusion 360 to design this project. Then my slicing software is slic3r currently. I keep my settings low. Then you get a strong durable part!
I hope you guys enjoy and use this!
1 Channel Relay Mount: http://www.thingiverse.com/thing:1284047
4 Channel Relay Mount: http://www.thingiverse.com/thing:1287530
8 Channel Relay Mount: https://www.thingiverse.com/thing:4992420
Stand-Off's are hole ready! (No drilling Necessary!!!)
Snap In Fit and flush mount
I also made this so that it can fit ~ 6mm Length screws. (board mount)
Lightweight & Strong Base Support!
I used Fusion 360 to design this project. Then my slicing software is slic3r currently. I keep my settings low. Then you get a strong durable part!
I hope you guys enjoy and use this!
1 Channel Relay Mount: http://www.thingiverse.com/thing:1284047
4 Channel Relay Mount: http://www.thingiverse.com/thing:1287530
8 Channel Relay Mount: https://www.thingiverse.com/thing:4992420
ScottieD369 veröffentlicht auch auf
48 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!