+2 For HiPower

+2 for Browning HiPower magazines. Not tested for .40 cal and .30 Mouser variants. Pierce Grip used to make +2s for the BHP but has long discontinued them. I am worried about breaking another one so Im making them.

Emboss around top of base plate is due to a thickness issue causing holes or gaps as geometry is less than 0.4mm thick and was not printed by my setup with 0.4mm nozzle.

Base Plate Revision R2 is untested though changes are purely cosmetic except reduced tolerance where the base plate slips onto mag body.

Follower Base R5 has added tolerance at the pin that holds the base plate in place. This should allow more misalignment when assembling.

Let me know if any changes should be made!