2 inch OD PVC T Coupling

Printed this coupling to fit in a new vacuum kick plate where space was tight, and commercially available couplings were too large to fit the space. It is recommended that the coupling be printed at the angle from the profile with the supports provided. I used PETG HF at 230 degrees and the aux fan at 100 percent. It will need cooling with the sheer amount of overhang a project like this requires. I'm sure it would work in PLA but this hasn't been tested. If you have issues with the overhangs, I'd suggest calibrating your filament with a temperature tower. All connections with the settings provided are very tight to reduce the need for glue. PETG and PVC cannot be bonded with traditional PVC cement, so if gluing is needed it is recommended to use a 2-part epoxy or other similar adhesive compatible with both materials. With my settings, supports came off easily, and I filed down the inside edges to help direct the connections in better.