2 meter Moxon antenna

Requirements:
3D printing
1x Mobile moxon heart.stl
1x Feedpoint.stl
2x spacers.stl
4x end button.stl

Buy or still in gray stock:

-4x fiberglass sticks with a diameter of 7.9mm, length 360mm. (found at the local camping store) this lenght is without the printed end caps.
-1x BNC connector chassis part.
Approximately 160cm RG58 coaxial cable.
-5cm heat shrink tubing
-2x bolt m4x12mm
-4x washer m4
-2x nut m4
-2x amp ring tongue m4 for 0.5mm2
-2x radiator 0.5mm2 length 44cm (to the center of the m4 bolts in the feeding point)
-1x reflector 0.5mm2 length 96cm
-4x plastic bolt m4x10mm for “spacers”

PLEASE NOTE! The above dimensions are after adjusting the antenna. So keep it a bit loose at first.

I did the calculation using the Moxon rectangle generator
Link: https://ac6la.com/moxgen1.html

This brilliant idea comes from OE5JFE and is hopefully an improvement.
Link: https://www.thingiverse.com/thing:3551736