Thingiverse
2 Part weighted Spinner
von Z33Fairlady
7
Downloads
5
Likes
0
Makes
Balanced Fidget Spinner
Fits standard 608 bearing. (8x22x7)mm
Design made myself in Fusion 360.
Hybrid design. I left cut-outs to fill with lead. Then superglue together to make it weighted.
Its a little longer than I wish I had made it but if you have standard-large hands, it works well. Although the picture shows the hole on 1 side, it is on both,. It was just for reference.
Cap Stl's are from Q8Khajah. They're great.
Please go check out his amazing work.
http://www.thingiverse.com/Q8Khajah/about
Fits standard 608 bearing. (8x22x7)mm
Design made myself in Fusion 360.
Hybrid design. I left cut-outs to fill with lead. Then superglue together to make it weighted.
Its a little longer than I wish I had made it but if you have standard-large hands, it works well. Although the picture shows the hole on 1 side, it is on both,. It was just for reference.
Cap Stl's are from Q8Khajah. They're great.
Please go check out his amazing work.
http://www.thingiverse.com/Q8Khajah/about
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!