Slicer Discord
2 piece style S20fe case – 3D-Druckmodell von Thingiverse Thingiverse

2 piece style S20fe case

von vecso
1 Downloads
8 Likes
0 Makes
Zum Modell
I loved the 2 piece case for my galaxy s8 (on the picture) but my new phone just got that bulky silicon style cases, it is a large phone in itselfe so i started looking, no luck. So i remixed a case that i found i use the original case for a while now and i like it just drilled some holes for chargeing and syncing you should checke it out too.
So for this case I cut it in pieces and made a hole for the charger, and done.
for the top part the camera bump hold the piece well enough for tke bottom half you might need some weak double sided tape or some bluetack, (the original for the have this lightli ticki tape in them but i dont know what it is or where to find so bee creative ;D (sorry my eanglish is awfull)

(for google translator)
szerettem a régen még az S8-hoz árul 2 részes tokot (ami a képen is van)de az uj telefonomhoz csak ezt a vastag szilikon tokot lehet kapni, a telefon magában nagy ezért elkezdtem keresgélni nem jártam szerencsével. ezért remixeltem azt a tokot egy
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
2-teiliger Zusammenbau
Supports 1/3
Zusammenbau 1/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

vecso veröffentlicht auch auf

2 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen