2" PVC Mushroom Cap Insert

**Use your slicer and rotate 180 degrees so you're printing mushroom side down. This will greatly reduce the amount of supports you'll need.

I made this to support a boat cover contraption I came up with. My cover would sag and collect water. I found that 2" pvc pipe slides right over the top of my table legs on my pontoon perfectly. I then used a 2 way sanitary tee at the top (see pictures) at the top and connected lashing straps that go between poles and front and back of the pontoon. I can set it up and take it apart in a couple minutes.

So this part....The sanitary tee is just open at the top. First try I zip tied foam from an extra mat. It fell apart from the friction within a couple weeks. I designed this part to fit right in the top of the sanitary tee and provide a nice smooth, convex surface for the boat cover to shift back and forth without ripping it. This is meant to insert inside a 2" pvc connector (external diameter 2.375").

The picture here was just a draft pri