Thingiverse
200 MM Lithophane light box
von VitterSkins
40
Downloads
23
Likes
0
Makes
a light box designed to fit curved 200 MM lithophanes. the LED strip this box was designed around was purchased via Amazon:
https://www.amazon.com/gp/product/B07TTP3YTP/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
the wireless receiver was glued inside and the break apart connector gets pushed through the hole in the back. it is a tight fit but was designed to keep the plug in place.
i added some hot glue to the strip as well to keep it in place as well as the wireless receiver for the remote control.
the 2 holes in the top are designed to fit 4 8x3 mm round magnets if you choose. but not necessarily needed.
https://www.amazon.com/gp/product/B07TTP3YTP/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
the wireless receiver was glued inside and the break apart connector gets pushed through the hole in the back. it is a tight fit but was designed to keep the plug in place.
i added some hot glue to the strip as well to keep it in place as well as the wireless receiver for the remote control.
the 2 holes in the top are designed to fit 4 8x3 mm round magnets if you choose. but not necessarily needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
