Thingiverse
200 mm quadcopter frame
von UncleMcNuts
6
Downloads
4
Likes
0
Makes
200 mm quadcopter frame for petg or abs 50% ish infill is recommended for weight
space for 30x15mm esc's on the under side of arms with slots for cable ties, space for a 36x36mm 4in1 esc or board on the bottom
motor wire cable routing
11mm at thinnest point on the arms
space for 30x15mm esc's on the under side of arms with slots for cable ties, space for a 36x36mm 4in1 esc or board on the bottom
motor wire cable routing
11mm at thinnest point on the arms
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!