200mm 3D Printed Quadcopter

I had some spare quad parts and figured I would build a quad using my 3d Printer, the parts I used where as follows...

- Chaos FPV 2205 2600KV Motors
- Spedix IS30A 4 in 1 ESC's
- Omnibus F4SD Flight Controller
- Foxeer TM25 VTX
- Runcam Micro Swift 2
- Foxeer RHCP Stubby Antenna
- Usual hardware
- Antenna adapter from Dec Kwad Box

Only thing I had to purchase was the XM receiver as I didn't have any spare.

I searched around Thingiverse for a frame that I could print on a 220mm build plate, once I found this I remixed the pod to incorporate the RX and made some small changes to the frame and other parts to fit the way I wanted to build this with the parts I had,

All in all I just wanted to share this little mini project and incorporate any remixes and credits to the original designers in one post.

This was all printed in the PLA other than the Antenna adapter but I had that in my Dec Kwad Box which was TPU.

Enjoy....