Thingiverse
Mendel Extruder Bottom Adapter
by bdudash
2
Downloads
10
Likes
0
Makes
This is a simple adapter to allow you to make use of the makerbot style plastruder tip on a mendel. This fits just below the extruder stepper assembly.
It contains two holes spaced the same as the makerbot retaining disc. The holes are NOT offset the same distance from center. One is 1mm closer. Don't ask me why they did this, but I mimic'd it. ^^
NOTE: You may need to change out the screws as the depth will increase when ;layering on this piece.
NOTE: You'll probably want to rework
It contains two holes spaced the same as the makerbot retaining disc. The holes are NOT offset the same distance from center. One is 1mm closer. Don't ask me why they did this, but I mimic'd it. ^^
NOTE: You may need to change out the screws as the depth will increase when ;layering on this piece.
NOTE: You'll probably want to rework
Sign in to leave a comment
Sign in