Thingiverse
2020 Corner Bracket, no screws needed
por jpnurro
30
Descargas
20
Likes
0
Makes
Corner bracket for 2020 V-slot profile. No disassembly of the frame, nor T-nut or screws needed.
Place the bigger half on the slot and slide the smaller ones in via profile. The locking bar goes over the smaller ones and will lock with the bigger one.
Bar is better to print vertically to achieve the maximum strength.
If the bracket feels loose adjust the 1st layer a bit higher.
Place the bigger half on the slot and slide the smaller ones in via profile. The locking bar goes over the smaller ones and will lock with the bigger one.
Bar is better to print vertically to achieve the maximum strength.
If the bracket feels loose adjust the 1st layer a bit higher.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
