Thingiverse

2020 Extrusion Flat Cable Holder

by ctheroux

1 Downloads

4 Likes

0 Makes

This is a clip to hold flat cables against a 2020 extrusion. It protects the
flat cable against damages that may be done by zip ties. You will need a 7.5
inches (190 mm) zip tie to install it.

Support material is not required. An infill of 20% is recommended.

This object main web page is:
http://www.ctheroux.com/2020-extrusion-flat-cable-holder/.

This object was designed using Solid Edge Community Edition.

You can request the source files on the page listed above.