2020 Side Mount for articulating camera arm

This side mount is for the "Articulating Raspberry Pi Camera Mount".

Since the original mounts are quite thin, this one was designed from scratch to be stronger & more durable.

Includes a thin slot for the ribbon cable for tidy cable management.

It's designed to fit onto the end of the Artillery/Evnovo Sidewinder X1 x-axis rail or any other 2020 rail.
No additional hardware required.

Even with a clean print it's a tight fit, so it requires a solid push to insert.
A snug fit is important so it doesn't wobble.

Print in the same orientation as shown, with supports, for a clean print.
Print it as a strong piece with at least 20% infill! You don't want the posts snapping off inside the tube.

Updated 29 Sep 2019: Extended the posts by 3 mm for stronger support