Thingiverse
Z Rod Assembly Support Anet A8
by genxter
138
Downloads
86
Likes
1
Makes
Dear community!
The correct way to install/assemble the Z Rod and Coupler is shown here:
https://3dprint.wiki/reprap/anet/a8/coupler
Most of you know this but who is has still problems with assembly can use this tools here to make sure everything is correct and not crooked.
Tested on Anet A8. Might work on other clones aswell.
Instruction:
1. Loosen up all bolts on the coupler.
2. Lift the coupler off the motor shaft.
3. Position the motor shaft as seen on picture one.
4. Sl
The correct way to install/assemble the Z Rod and Coupler is shown here:
https://3dprint.wiki/reprap/anet/a8/coupler
Most of you know this but who is has still problems with assembly can use this tools here to make sure everything is correct and not crooked.
Tested on Anet A8. Might work on other clones aswell.
Instruction:
1. Loosen up all bolts on the coupler.
2. Lift the coupler off the motor shaft.
3. Position the motor shaft as seen on picture one.
4. Sl
Sign in to leave a comment
Sign in