(2025) Rear Storage Compartment Knobs - 3rd Gen Toyota 4Runner

This remix combines the two pieces from the original model into a single piece for printing with supports thus removing the need to glue any pieces together after printing

Print with 50% or more infill, I used 100% for added strength around the screw hole

OEM Toyota screw must be heated with lighter or blow torch on the end of a screwdriver or pliers to melt threads into the printed piece during reassembly

Screw snugly but do not over tighten or you risk cracking the PLA, other filament materials can be used at your discretion although your results may vary

UPDATE: 01/07/2025

Adjusted height by 2mm~ for better fitment

Currently testing with M5 bolts threaded directly into the plastic (without heat), with washers on each side of the metal Toyota door latches