2040 Extension for MFT table (Festool)

Extension for when using a 2040 extrusion as a fence on a MFT table, this model can be used with either guide rail benchdogs, guide rail dog hooks or with some sort of rail hinge. The tip of the extension is printed with 100% infill and a little bit lower and will be cut off when you make the first cut, this is by design as it gives you the actual zero point of your blade and gives you a good point to measure from when setting flipstops or aligning marks. THIS IS FOR THE FESTOOL GUIDE RAILS (Bosch/Mafell version availible here: https://makerworld.com/en/models/2160847-2040-extension-for-mft-table-bosch-mafell#profileId-2342819) Rather than cutting down the 2040 aluminum extrusion for use as a fence on a MFT top this attaches to the extrusion as an extension which goes down to 8 mm letting you cut material down to 9 mm with full contact of the track. You will need some hardware:1 M5 nut for attaching the dog1 countersunk M5 machine screw2 M5x20 bolts2 T-nuts for attaching the extrusion