Thingiverse
2060 Spool Holder
by demigh0d
5
Downloads
0
Likes
0
Makes
Filament spool holder mounts on top of 2060 extrusion. Designed to allow wiring to still be run on top of extrusion.
Right and Left versions so they can be bolted together back-to-back when running multiple extruders.
Uses 608 bearings, M3 locknut and M3x20 (single) or M3x35 (double) bolt.
Works with TriangleLab filament sensor bracket at https://www.thingiverse.com/thing:2828117
2018-03-15: Fixed problem with left and right sides not lining up. Also made them a bit higher so the spool stays in place better.
Right and Left versions so they can be bolted together back-to-back when running multiple extruders.
Uses 608 bearings, M3 locknut and M3x20 (single) or M3x35 (double) bolt.
Works with TriangleLab filament sensor bracket at https://www.thingiverse.com/thing:2828117
2018-03-15: Fixed problem with left and right sides not lining up. Also made them a bit higher so the spool stays in place better.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!