HC-05 / HC-06 Programming Holder

Every time I wanted to flash the firmware on an HC-05 / HC-06 I ended up soldering temporary wires to the SPI Pads and once I'd finished programming, removing them. Thankfully now I don't have to! This holder gives you access to the 4 SPI pins along the bottom plus the VCC and GND on the left hand side.

**Wires used**
I used some standard single core breadboard / jumper wire. I believe its 22AWG. Stranded wire is not worth trying.

** Holding the chip in place**
I've used both elastic ban