20mm_Soft_Measure_Tape_Spool

An enclosed spool for a 20mm wide soft tape up to 150cm comprised of four pieces: an inner and and outer top and bottom.I remixed this from the13mm design of Halfway_Engineered and @PeaglerSci_1867846 from printables to 20mm measure tape.Assembly InstructionsPlace the inner bottom piece down on a flat surface.Fit the outer bottom piece over the inner bottom piece.Place the end of your soft tape into the slot on the inner bottom piece.Fit the outer top piece in place by pressing it into the matching groove on the bottom piece.Place the inner top piece onto the spool assembly, taking care to line up the slot for the end of the soft tape.Press firmly to secure.NOTE: The pins on the bottom piece often break when attempting to take the inner pieces apart.Do NOT join the inner pieces until final assembly.My print:Orca SlicerCreality K1CCreality ender PLA +0.16 Layer hight3 wall loops5% infillGyroid pattern for infill