Thingiverse
20x20 quadcopter pod
von borjos
15
Downloads
6
Likes
1
Makes
What is this:
this is a pod that can use any quadcopter arms that have 30.5 pattern holes and are interlocking.
Other limitations in use:
microcam (19mm wide) only
best used with 20x20 stack
will fit 3 layer stack with 6mm standoffs
How to print the pod:
ABS (or tpu)
on its side
supports on
this is a pod that can use any quadcopter arms that have 30.5 pattern holes and are interlocking.
Other limitations in use:
microcam (19mm wide) only
best used with 20x20 stack
will fit 3 layer stack with 6mm standoffs
How to print the pod:
ABS (or tpu)
on its side
supports on
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!