Thingiverse
Ultimaker 2 / 2+ Cam Holder
by conny_g
10
Downloads
12
Likes
0
Makes
Print the base upside down and the holder sideways.
Mount the upper part to the base either with 2 M4 screws (10mm) or melt in M3 nuts in the upper part (these special melt-in nuts, I love them...).
Use the two chassis screws at the corner to fix the mount.
Depending on the cam you use you need a regular cam fixture screw, or print this:
http://www.thingiverse.com/thing:578514
(This screw is actually too small in diameter for me and the thread does not fit).
Print settings or mater
Mount the upper part to the base either with 2 M4 screws (10mm) or melt in M3 nuts in the upper part (these special melt-in nuts, I love them...).
Use the two chassis screws at the corner to fix the mount.
Depending on the cam you use you need a regular cam fixture screw, or print this:
http://www.thingiverse.com/thing:578514
(This screw is actually too small in diameter for me and the thread does not fit).
Print settings or mater
Sign in to leave a comment
Sign in