Thingiverse
Table Brace Bumper
by Gazorpa
6
Downloads
12
Likes
0
Makes
Our late dumpster era dining table has a wicked sharp edge on a supporting brace. The kids are almost tall enough to put a dent in their skull when they stand up.
I could file the end of the brace round, but this solution is more fun. The brace cross-section is 52 x 26 mm. It already has one screw about where I wanted to anchor it, so I made 3 mounting holes for good luck. One short #8 or #10 screw will hold it in place.
I could file the end of the brace round, but this solution is more fun. The brace cross-section is 52 x 26 mm. It already has one screw about where I wanted to anchor it, so I made 3 mounting holes for good luck. One short #8 or #10 screw will hold it in place.
Sign in to leave a comment
Sign in