Thingiverse
CR-10 Redesign Fan Mount/Shroud/Duct
by donnyb99
331
Downloads
147
Likes
2
Makes
This is my redesigned fan mount for both the hotend heatsink fan and the nozzle fan. It combines both fans into a single mount. Note that this fan shroud uses 50mm x 50mm. The stock fans are 40mm x 40mm.
You will also need 2x M3x8 and 2x M3x16 or 20.
It uses the pre-existing holes in the x-axis carriage to mount. I have noticed vastly improved cooling performance especially with ABS. The old hotend heatsink fan used to blow lots of cold air onto the print bed. This design eradicates that i
You will also need 2x M3x8 and 2x M3x16 or 20.
It uses the pre-existing holes in the x-axis carriage to mount. I have noticed vastly improved cooling performance especially with ABS. The old hotend heatsink fan used to blow lots of cold air onto the print bed. This design eradicates that i
Sign in to leave a comment
Sign in