Thingiverse
FIlament Holder
by Dudux
14
Downloads
7
Likes
0
Makes
Filament holder for Prusa Hephestos I3
Allows smooth sliding of the coil, avoiding pulling.
In addition to the printable parts you need the following components:
Two bearings with 22 mm outer diameter and 10 mm internal diameter.
A threaded rod of at least 176 mm in length and 10 mm in diameter.
Description of parts:
* 2 x Soporte.stl - Side supports.
* 2 x Sop_Bobina_Huecos.stl - Supports coil.
* 2 x Tope_Roda_C.stl or Tope_Roda.stl - Side nuts, the threads must be made by f
Allows smooth sliding of the coil, avoiding pulling.
In addition to the printable parts you need the following components:
Two bearings with 22 mm outer diameter and 10 mm internal diameter.
A threaded rod of at least 176 mm in length and 10 mm in diameter.
Description of parts:
* 2 x Soporte.stl - Side supports.
* 2 x Sop_Bobina_Huecos.stl - Supports coil.
* 2 x Tope_Roda_C.stl or Tope_Roda.stl - Side nuts, the threads must be made by f
Sign in to leave a comment
Sign in