Thingiverse

Filament Grommet / Container (1.75mm bowden)

by Coffea

16 Downloads

13 Likes

0 Makes

Download Model

175mm 175mm filament ABS bowden container filament container filament grommet filament guide filament holder filement Filiment grommet m3 screw PLA 175mm 175mm filament ABS bowden container filament container filament grommet filament guide filament holder filement Filiment grommet m3 screw PLA 175mm 175mm filament ABS bowden container filament container filament grommet filament guide filament holder filement Filiment grommet m3 screw PLA

Filament grommet designed to brace the walls or lid of a plastic tub or tote, Center hole is 3mm diameter and requires a short section of bowden tubing for a low friction "air tight" seal. Parts are affixed together either side of the container wall / lid with 3x 8mm M3 bolts (no nuts required although can be used with longer bolts).

The seal is not strictly airtight as there will be a gap between the filament and the inside of the bowden tubing and the act of removing filament from the conta

Source

Thingiverse

Comments