Thingiverse

Spool Spindle And Washers

by TheFuzz1542

2 Downloads

1 Likes

0 Makes

Download Model

adapter adaptor filament-spool filament holder filament spool holder mount rollor spool spoolholder spool adapter spool holder spool roller adapter adaptor filament-spool filament holder filament spool holder mount rollor spool spoolholder spool adapter spool holder spool roller adapter adaptor filament-spool filament holder filament spool holder mount rollor spool spoolholder spool adapter spool holder spool roller

Spool roller for standard width spools. It's fat but not fat enough to fully fit the spool hole, did this so it would spin freely. If this is going on a threader rod I would suggest to put the rod in a drill and run while holding spool holder and moving it back and forth just to clean out any burs and to help it spin freely. 10 - 15% infill should be plenty. If nuts are going against the spool washer what I would do is finger tighten the nut against the washer then move it back 1/4 of a turn. Th

Source

Thingiverse

Comments