Thingiverse
Toothbrush Holder
by jacobn6
6
Downloads
12
Likes
0
Makes
Simple little toothbrush holder I designed for my bathroom after my old one broke. I made it an open concept so it will be easy to clean in the long run.
Materials:
4 Qty. 8mm hex nuts
1 Qty. 8mm x 130mm threaded rod
This was printed in PLA, but any material will work. The bottom is designed to be heavy enough so that even when there is only one brush in the holder, the holder will not tip.
Materials:
4 Qty. 8mm hex nuts
1 Qty. 8mm x 130mm threaded rod
This was printed in PLA, but any material will work. The bottom is designed to be heavy enough so that even when there is only one brush in the holder, the holder will not tip.
Sign in to leave a comment
Sign in