Moducase - Modular enclosure for electronics. Designed for the Anet A8

Update 8/12/17
I revised the covers and connecting splice due to a mis-alignment of the holes. I had printed them but didn't put them on until yesterday when I found out they were off 2-3mm in each direction. Trying to figure that one out.

Project now completely printed and done.

Update 8/1/17
I have printed this and fixed almost all errors. There is still misalignment with the mosfet mounting holes and the unit is 4-5 mm too wide to fit between the sides. I am planning to fix it when