Thingiverse
City Side Light
by MintyTrebor
17
Downloads
15
Likes
0
Makes
Simple City side light design. Feet should just push into base, but you may need to resize hole/plugs depending on your printer.
Printed base and top at 0.20 layer height, feet at 0.35, all in PLA on i3 MK2.
I used normal opaque white PLA for the top part. It is very thin which acts as a good diffuser.
You will need to add bulb holder and plug / cable etc (I used ones from 2 cheap IKEA side lights which were £3 each)
Base : https://tinkercad.com/things/7SPKjmtI1Jk
Top : https://tinker
Printed base and top at 0.20 layer height, feet at 0.35, all in PLA on i3 MK2.
I used normal opaque white PLA for the top part. It is very thin which acts as a good diffuser.
You will need to add bulb holder and plug / cable etc (I used ones from 2 cheap IKEA side lights which were £3 each)
Base : https://tinkercad.com/things/7SPKjmtI1Jk
Top : https://tinker
Sign in to leave a comment
Sign in