Thingiverse
Anet A8 Standard Filament Holder Bearing
by wastelgoeg
7
Downloads
1
Likes
0
Makes
This is a small piece, that can be put on the original holes of the original Filament holder for the Anet A8.
I used brass bearings with 8 mm inner and 12 mm outer diameter.
I tooked these bearings form the differential of a Tamiya TT 01 chassis (Tamiya - 0555015).
You need to print this part two times, so your M8 Rod is fixed on both sides. After this you only need the two nuts in the spoon cones. The other four nuts must be removed.
I use it with these spool cones: http://www.thingiv
I used brass bearings with 8 mm inner and 12 mm outer diameter.
I tooked these bearings form the differential of a Tamiya TT 01 chassis (Tamiya - 0555015).
You need to print this part two times, so your M8 Rod is fixed on both sides. After this you only need the two nuts in the spoon cones. The other four nuts must be removed.
I use it with these spool cones: http://www.thingiv
Sign in to leave a comment
Sign in