Thingiverse
X-motor End for Prusa I3
by rball716
51
Downloads
29
Likes
1
Makes
Replacement X-motor end for the Prusa I3. Design to match my X-Idler.
No support necessary as long as you can bridge 25mm. Print out my 25mm bridge test if you are unsure. Some stringyness is fine as long as you do some cleanup. Drilling out the holes is always a good idea.
No support necessary as long as you can bridge 25mm. Print out my 25mm bridge test if you are unsure. Some stringyness is fine as long as you do some cleanup. Drilling out the holes is always a good idea.
Sign in to leave a comment
Sign in