Anet A8 Front Frame Brace [Superstiff]

Basically the same as Leo's thing (https://www.thingiverse.com/thing:1857991) which is pretty much an improvement.

Though i had to add a little piece that wraps through the bottom gap of the original frame part and prevent its lower outer edge from bending too. Fits perfect to my A8 and gives Leo's thing a good pinch of extra stiffness.

**NOTE:**
Make sure that your slicer program is set to 100% scale. You will also need to rotate to object 45 degrees to make it fit on the heat bed.

Ha