Thingiverse
SmallSimpleSpinner
by listronicus
8
Downloads
2
Likes
0
Makes
Simple fidget spinner. The bearing is built in and prints in place. The caps should snap fit.
When printed in PLA works ok, I have not tried other materials. I'll post the Openscad script once I clean it up a bit more. My only ask is that you don't use it to take over the world.
Small update, should fit togeather a bit better and I rounded the edges more.
Reweaked the size of the hole in the bearing (first it was too tight, then it was too loose, I'm hoping this will just right) and
When printed in PLA works ok, I have not tried other materials. I'll post the Openscad script once I clean it up a bit more. My only ask is that you don't use it to take over the world.
Small update, should fit togeather a bit better and I rounded the edges more.
Reweaked the size of the hole in the bearing (first it was too tight, then it was too loose, I'm hoping this will just right) and
Sign in to leave a comment
Sign in