Thingiverse
Drela AG36 Airfoil Micro Drone Propeller (34.95g thrust @3V)
by emanuelbucsa
36
Downloads
36
Likes
0
Makes
I designed this propeller using the **Drela AG36** airfoil coordinates. All tests were performed on the **[Micro Drone Propeller Thrust Tester](http://www.thingiverse.com/thing:2302071)** The results can be seen below.
It was printed slowly, with a **[0.2mm nozzle](http://amzn.to/2qQdFvg)** at 0.04mm layer height. I cleaned the final part using an **[X-ACTO Knife](http://amzn.to/2pV1sGA)**
After this, I got to finishing the part using a **[400 grit sandpaper](http://amzn.to/2pTNwic)**.
It was printed slowly, with a **[0.2mm nozzle](http://amzn.to/2qQdFvg)** at 0.04mm layer height. I cleaned the final part using an **[X-ACTO Knife](http://amzn.to/2pV1sGA)**
After this, I got to finishing the part using a **[400 grit sandpaper](http://amzn.to/2pTNwic)**.
Sign in to leave a comment
Sign in