Thingiverse
hictop deported extruder
by stilther
11
Downloads
0
Likes
0
Makes
for put the extruder motor on the frame of your hictop 3d printer, with support for connector and place to put a filament cleaner.
You need 2 x M5 x10mm and 3 x M3 screw
you can use the 2 original piece of the extruder
I take 1 hour to make this 3 parts and assembled them.
you can just print the motor support and put your own ptfe support, for exemple a mk8 extruder.
To block the connector you can use the little piece, remove the cap of the connector and put the to screws in holls
You need 2 x M5 x10mm and 3 x M3 screw
you can use the 2 original piece of the extruder
I take 1 hour to make this 3 parts and assembled them.
you can just print the motor support and put your own ptfe support, for exemple a mk8 extruder.
To block the connector you can use the little piece, remove the cap of the connector and put the to screws in holls
Sign in to leave a comment
Sign in