24 regular sharpie pen holder

I had more than 12 sharpies and needed a holder to hold them all plus have room to add more. This holder has 2 holes in the back so you can mount it on a wall. But it really works better on the desk of workshop table. I added a little curved tray at the bottom. When I was using the sharpies, often I would use 2 or 3 different colors at a time. so instead of laying them on the table and rolling off, I set them in the tray. This holder will fit the normal size sharpies, NOT THE FAT ONES OR THE SKINNY ONES, although the skinny ones would fit very loosely in the holes.

PRINT DETAILS
The holder should be placed right side up on the build plate. It should already be oriented that way.

I use a rim, only to purge my hot end before the print, but if you have problems with your prints adhering to your build plate, then I suggest using a raft.

I did use the standard support to the build plate only. Because of the gap on the base of the model support is n