Thingiverse
Tronxy X1 part cooling fan shroud
by JoFi
18
Downloads
7
Likes
0
Makes
For radial fan BD125015MB 50x50x15mm.
Bolts directly to the M3 threads at the side of the extruder cover. One hole of the fanmount is 1-2mm off or so, need to do a little update later. But works also with only one bolt.
Fan (just red & black wire) just needs to be connected to the "FAN" port of the Melzi board and it works right away with the settings from the slicer (firmware already configured).
ATTENTION - VERY POWERFUL! ;-)
My experience: Use max. 80% fan speed or insulate your heate
Bolts directly to the M3 threads at the side of the extruder cover. One hole of the fanmount is 1-2mm off or so, need to do a little update later. But works also with only one bolt.
Fan (just red & black wire) just needs to be connected to the "FAN" port of the Melzi board and it works right away with the settings from the slicer (firmware already configured).
ATTENTION - VERY POWERFUL! ;-)
My experience: Use max. 80% fan speed or insulate your heate
Sign in to leave a comment
Sign in