Thingiverse
Downspout Diverter
by TheFisherOne
50
Downloads
22
Likes
0
Makes
This was a quick project that was done for a friend.
In order to get progressive curves I used a for loop. I picked 1mm steps which is a little rough, but is a good compromise with speed of rendering. I might play with this later to make the step size configurable. After all it takes much longer to print than it does to render.
The basic idea is that water flowing down the water spout will hit the diverter and spread out instead of just digging a hole in one spot.
Print large side down an
In order to get progressive curves I used a for loop. I picked 1mm steps which is a little rough, but is a good compromise with speed of rendering. I might play with this later to make the step size configurable. After all it takes much longer to print than it does to render.
The basic idea is that water flowing down the water spout will hit the diverter and spread out instead of just digging a hole in one spot.
Print large side down an
Sign in to leave a comment
Sign in