Thingiverse
Connector set for 100mm 10cm dryer duct
by Cpt_Unstable
45
Downloads
23
Likes
0
Makes
This is a set of printer housing accessories.
I created this to get rid of the printing fumes.
Got useful especially after fitting a laser diode for engraving to my Anet A8.
It is designed to go onto an existing printer housing, mine was made out of polycarbonate.
All you need is four small holes for the screw and a 30mm hole for the air.
The air hole is kept small so you can use a standard 32mm step drill, as the output port of the fan is aprox. the same area.
I hope the parts are sel
I created this to get rid of the printing fumes.
Got useful especially after fitting a laser diode for engraving to my Anet A8.
It is designed to go onto an existing printer housing, mine was made out of polycarbonate.
All you need is four small holes for the screw and a 30mm hole for the air.
The air hole is kept small so you can use a standard 32mm step drill, as the output port of the fan is aprox. the same area.
I hope the parts are sel
Sign in to leave a comment
Sign in