Hypercube Evolution X-Carriage for 10mm rods

Hypercube Evolution X-Carriage designed for use with 10mm ID x 16mm OD bearings. The following has been changed from the Nach0z remix:
1. Increased the wall thickness of the bearing retainers.
2. Reduced the depth of clamp fastener holes to clear bearing retainer wall.
3. Added 1.5mm height to the clamp mounting surface to clear bearing retainer wall.
4. Remixed belt clamps to fit.

7/1/17 Added a 10mm Y End Stop


I'm using carbon fiber 10mm rods with PTFE bearings from McMaster:
htt