Thingiverse
Friction Pin Test
by doctriam
0
Downloads
3
Likes
0
Makes
This is a test print I did before working on a different project. There are 6 pieces:
1 top plate
1 base plate
2 pin bases
2 pin caps
The spacing between the cylinders is 0.1 mm, and the spacing between faces is 0.2 mm.
On my print, the pin bases are flush with the bottom of the base plate, and the tops of the pin caps sit about 1 to 2 mm above the top of the upper plate.
It took quite a bit of force to pull the plates apart once it was fully assembled, but, obviously, pulling it
1 top plate
1 base plate
2 pin bases
2 pin caps
The spacing between the cylinders is 0.1 mm, and the spacing between faces is 0.2 mm.
On my print, the pin bases are flush with the bottom of the base plate, and the tops of the pin caps sit about 1 to 2 mm above the top of the upper plate.
It took quite a bit of force to pull the plates apart once it was fully assembled, but, obviously, pulling it
Sign in to leave a comment
Sign in