Thingiverse
Apple Pencil Holder
by gertlind
14
Downloads
9
Likes
0
Makes
Print as shown in the first picture.
Support is not needed.
The lighting contact i used was an Apple original. Not sure if dimensions can vary on clones.
I also did cut off mine so about 3mm of the shell was left, this to make the build more compact.
Glue the Lightning contact to the holder.
Inspired by https://www.thingiverse.com/thing:2413104
Support is not needed.
The lighting contact i used was an Apple original. Not sure if dimensions can vary on clones.
I also did cut off mine so about 3mm of the shell was left, this to make the build more compact.
Glue the Lightning contact to the holder.
Inspired by https://www.thingiverse.com/thing:2413104
Sign in to leave a comment
Sign in