Thingiverse
Kossel Auto hight adjusting camera Mount 20mm Extrustion
by prusanoff
9
Downloads
9
Likes
0
Makes
Hey Guys
I quickly made this for my Logitech camera that is connected to Raspberry-Pi. I always had a hard time getting a good angle on the print or a good distance so you could see the print clearly from a good vantage point.
This is made for 20X20mm extrusion to slide up and down easily with a simple push of the finger. You might want to add 1-3% to the size. I had to do some sanding after but it came out great.
You can tape glue or rubberband your camera to the arm on the side. Now
I quickly made this for my Logitech camera that is connected to Raspberry-Pi. I always had a hard time getting a good angle on the print or a good distance so you could see the print clearly from a good vantage point.
This is made for 20X20mm extrusion to slide up and down easily with a simple push of the finger. You might want to add 1-3% to the size. I had to do some sanding after but it came out great.
You can tape glue or rubberband your camera to the arm on the side. Now
Sign in to leave a comment
Sign in